4
CLEAN THE FILTER BAG AFTER EVERY CLEANING CYCLE
a. Unplug the power supply. (Please keep the plug away from contact with water)
b. If the unit is in the pool, gently pull the cleaner toward you using the cable until the handle is within reach. Use the handle (not the cable) to pull the
cleaner out of the pool after allowing most of the water to drain from the unit.
c. Lay the unit on its back on a smooth surface (in order to prevent scratches on the machine body), release the lock tabs and remove the bottom lid
assembly. (fig.4a, 4b, 4c, 4d)
d. Remove the filter bag from the support bars, turn it inside out and wash off all the dirt with a garden hose or in a sink. Squeeze the bag gently until the
rinse water is clear. If necessary, machine wash the bag using only cold water with NO DETERGENT! (fig.5)
e. Re-install the bag on the support bars with the label in the center of one of the long sides of the bottom lid (5a)
f. Re-install the bottom lid assembly in the body. Push down on it until lock tabs will snap into place properly.
Maintenance and adjustment
Shut off and unplug the power supply every
time you remove the cleaner from the water.
Clean the filter bag after every cycle.
Reverse the handle after every cleaning cycle to
avoid tangling the cable.
Periodically straighten out the floating cable.
Replace worn brushes to ensure maximum
cleaning performance
Make sure that your pool cleaner positions itself
properly on the wall. The machine handle must
rest parallel to the water line upon reaching the
surface of the water.
Save your cleaner's packaging for off-season
storage or for shipping the unit to your dealer if
service is required.
Leave your pool cleaner in the water for 15 to 20
minutes after every cleaning cycle.
Do not leave your cleaner in direct sunlight
when not in use.
Never leave the power supply in direct
sunlight and avoid leaving it in the rain.
Occasionally, you should rinse your cleaner in
clean, fresh water. This will lengthen the service
life of the drive belts, drive tracks and scrubbing
brushes.
Clean the propeller once a month
(see next page for details)
IMPORTANT TIPS:
label
lock tab
smooth
surface
smooth
surface
To Next Page
Loading...
Need help?
General