10
Adjusting the Vertical Hood Position
The vertical position of the hood must be adjusted to centralise it with
the camera lens.
1. Loosen the two lock screws to adjust the position of the hood on
the rods.
2. Adjust the vertical position of the hood to centralise it with the
camera lens and fully re-tighten the lock screws.
Adjusting the Prompter Assembly Position
The horizontal position of the prompter assembly must be adjusted to
optimise its position relative to the camera position.
1. Loosen the twist locks on the telescopic rods and move the
prompter assembly back until the hood overlaps the camera lens.
2. Tighten the twist locks to secure the assembly.
Installation
To Next Page
Loading...