EasyManua.ls Logo

AUTOTERM PU-28 - Page 2

AUTOTERM PU-28
21 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
Introduction
This Operating Manual contains general information for
the user on safe maintenance and operation of the product.
In case of any problems, we strongly recommend that you
contact authorised service centres, the addresses and phone num-
bers of which you can obtain from the seller or on the www.au-
toterm.com website.
Before operating the product, read this oper-
ating manual and the heater operating man-
ual.
Warranty and liability
The manufacturer will not be liable for defects and dam-
age caused by failure to follow the heater installation and mainte-
nance instructions.
The control panel can only be used to control liquid heaters
Flow 5, Flow 6, Flow 10, Flow 14 and air heaters Air 2D,
Air 4D, Air 9D.
Do not connect and disconnect the control panel connector
while the liquid/air heater is operating.
After the product is switched off, it should not be switched on
again for at least 510 seconds.
For safe product operation, after two unsuccessful attempts to
start the product in a row, contact the service department for
troubleshooting information.
The warranty operating period and the conditions of warranty ser-
vice are specified in the warranty certificate.

Related product manuals