7
7
If you connect the transmitter to an audio source headphone
jack, set the audio source’s volume to the middle position.
Then adjust VOLUME on the headphones to the desired level.
Turn off the headphones before turning off the transmitter.
This prevents you hearing a loud click that may be generated
when you turn off the transmitter.
Specifications
Transmitter:
Carrier Frequency ......................................911.4 and 915.6 MHz
Power Source ................................12V DC, 250 mA AC Adapter
Modulation Method ............................................FM Modulation
Receiver:
Sensitivity ................................................ <2µV (with 20 dB S/N)
S/N Ratio (@-50dBm) ...................................... >60 dB (A weight)
Audio Distortion .................................................................. <2%
Max. Audio output ............................................................ 8 mW
Channel Separation ........................................................... >45dB
Operation Distance .................................up to 150 feet (45.72m)
Power requirement .......3 AAA alkaline or rechargeable batteries
................................................................................(not included)
Overall Frequency Response ....................................80Hz-20KHz
Specifications are subject to change and improvement without notice.
Actual product may vary from the product images in this document.
FCC Information
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protec-
tion against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
To Next Page
Loading...
