AVA Pressure washer P60/P70 / P80
| 7
Warning! Switch off, remove plug
from mains before adjusting,
cleaning or if cable is cut,dam-
aged or entangled.
The operating voltage is 230 V AC,
50 Hz (for non-EU countries 220 V,
240 V as applicable). Only use ap-
proved extension cables. Contact your
AVA Service Centre for details.
If you want to use an extension cable
when operating your high pressure
washer, only the following cable
dimensions should be used:
– 2.5 mm2 – max length 25 m
Note: If an extension cable is used
it must be earthed and connected
through the plug to the earth cable
of your supply network in accordance
with prescribed safety regulations. If
in doubt contact a qualified electrician
or the nearest AVA Service Centre.
WARNING! Inadequate extension
cables can be dangerous.
Extension cable, plug and socket
must be of watertight construction and
intended for outdoor use
.
Cable connections should be kept dry
and off the ground.
For increased electrical safety use a
Residual Current Device (RCD) with a
tripping current of not more than 30
mA. Always check your RCD every
time you use it.
If the supply cord is damaged, it must
be replaced by a AVA Service Centre.
Action Fig-
ure
Page
Connecting the
water supply
5 51
Start procedure 6 51
Locking/Unlocking
the gun
7 51
Cleaning the water
filter
8 52
Cleaning the
nozzle
9 52
Attaching the
Zoom Lance
10 52
Attaching the
Fixed Nozzle
11 53
Attaching the
Foam Cannon
12 53
Using the Foam
Cannon
13 54
Attaching the Vari-
able Nozzle
14 54
Using the Variable
Nozzle
15 54
Changing LED
battery
16 55
Attaching the Roto
Nozzle
17 55
Attaching the Patio
Cleaner
18 55
Adjusting the
Zoom Lance
19 56
Storing accesso-
ries
20 56
Starting
For Your Safety
English
To Next Page
Loading...