AVAPressure washer P60/P70 / P80
4 |
English
hoses, fittings and couplings rec-
ommended by the manufacturer.
Only clean or filtered water should
be used for intake.
Application
Before use, check that the unit and
operating equipment are in perfect
condition and are safe to operate.
Do not use the unit if it is not in
perfect condition.
Do not direct the jet against
yourself or others in order to clean
clothes or footwear.
Do not use solvent-containing
liquids, undiluted acids, acetone or
solvents! This includes petrol, paint
thinners, heating oil. The sprayed
vapor is highly flammable, explosive
and toxic.
The appropriate safety regulations
must be observed when using the
unit in dangerous areas (e.g. petrol
stations). It is forbidden to operate
the unit in potentially explosive
locations.
The unit must be placed on a solid
base.
Take care if using the machine in a
confined space ensuring that there
is adequate ventilation. Ensure that
all vehicles are switched off at all
times whilst cleaning.
Operation of this machine requires
both hands to be used at all times.
Do not operate from a ladder. Take
care when using the machine on
balconies or other raised areas en-
suring that you can see any edges
at all times.
Only use detergents recommended
by the manufacturer. Comply with
the application, disposal and warn-
Protect the cable from heat, oil and
sharp edges.
Do not use the unit, if the power
supply cord or important parts, e.g.
high-pressure hose, power gun or
safety devices are damaged.
Warning: Inadequate extension
cords can be dangerous.
If an extension cord is used, the
plug and socket must be of water-
tight construction. The extension
cord must have a cross section in
accordance with the operating in-
structions and be protected against
splashed water. The connection
must not be in water.
When replacing plugs on the power
supply cable or extension lead the
spray water guard and mechanical
stability must remain intact.
Water connection
Comply with the regulations of your
water supply company.
All connecting hoses must have
properly sealed joints.
Make sure that the supply hose is
at least 12.7 mm (1/2”) in diameter
and is reinforced.
The appliance should never be
used on the drinking water supply
without a back flow valve. Water
which has passed the back flow
valve is regarded as undrinkable.
The high-pressure hose must not
be damaged (danger of bursting).
A damaged high-pressure hose
must be replaced immediately. Only
use hoses and connections recom-
mended by the manufacturer.
High-pressure hoses, fittings and
couplings are important for the
safety of the appliance. Use only
To Next Page
Loading...
