11(14)
7.1. Troubleshooting
PROBLEM POSSIBLE CAUSE SOLUTION
No or too little oil
Stop immediately, check the loader hydraulic oil
level and add oil
Carriage movement incorrectly
adjusted
Adjust carriage movement
Oil too cold Let oil circulate freely for a few minutes
Broken or leaking hose or other
hydraulic component
Stop the use, replace broken components
No splitting action
Frozen Melt nad clean the equipment
Oil too cold
Slow or weak
splitting action Too little oil
Anna öljyn kiertää vapaasti
Lisää öljyä
Incorrect blade position Adjust blade position
Large knot at splitting point Stop splitting, turn log
Log too large Max diameter 40 cm
Log does not split
Decreased oil pressure Check hydraulic system (section 7.2)
Log rises up
Unsuitable log dimensions or many
branches
Check carriage stroke
Remove branches
Incorrect stroke of carriage Extend carriage stroke
Log gets jammed
on blade
Blunt blade Sharpen the blade
7.2. Hydraulic system
The hydraulic pressure of the log splitter can be checked from the flow regulator valve shown below. To check
and adjust the pressure suitable equipment is needed. Contact service if the log splitter does not function
properly.
Locking nut
Pressure in
Pressure to cylinder piston
Hydraulic flow divider is regulated for pressure 200 bar.
If necessary (normal job is disturbed) the pressure should
be checked. When turning the adjustment screw clockwise.
the pressure will increase.
To Next Page
Loading...