Avanti Hearth Products
Z60
INSTALLATION AND OPERATING INSTRUCTION
If you are unable to read or understand these instructions
do not attempt to install or operate
Please keep these Instructions for future reference.
☆
INTRODUCTION
The Avanti Z60 thermal remote control system was developed with the latest radio frequency (RF)
technology. The Avanti Z60 is easy to install. It allows the user to operate a gas appliance manually or
thermostatically with a user-friendly remote control system which does not require any household electric
current. The range of operation is approximately 20 feet (7 meters). The operating code of this remote
control system has been pre-programmed for instant operation after installation. However, its special
code-learning feature (on the receiver) allows the user to regulate the codes for operating with other
transmitters for a maximum flexibility. Note: installation in metal cabinets may limit the range of operation
☆
COMPONENTS INCLUDED
TRANSMITTER
WALL-MOUNT COVERPLATE
SLIDE BUTTONS
WALL MOUNT
BRACKET
Description QTY
Transmitter 1
“AAA” Batteries 2
Wall Mount Bracket (with Screws) 1
Receiver 1
“AA” Batteries 4
Wall Mount faceplate (with Screws) 1 7) Velcro at the bottom of the box
Hearth Mount Slide knob (Black) 1
To Next Page
Need help?
General