Bass reflex box
The recommended amount of liters
Port area, cm²
Port length, cm.
Hz setting
50
90
150 200
62 40
35 35
Parameters/Model
SST-12 SST-15
L*W*H = body volume
4.RECOMMENDED ENCLOSURE P A R A M E T E R S
The correct choice of the amplifier, its settings and design prolong the lifetime of your subwoofer. You should select an
amplifier with a nominal power below the nominal power of the subwoofer. Proper coordination of the head unit (HU) with the
amplifier will provide a clean, undistorted signal fed to the subwoofer, which prevents overheating and voice coil damage. Like
any other speaker the subwoofer has moving and stationary parts. We strongly recommend that the moving parts of the
subwoofer should be warmed up at the beginning of operation. Be extra careful when warming up the parts. Warm up the
subwoofer using musical material for 40 hours on medium power. If, during operation at maximum volume you feel strange
smell, you should make the volume of the subwoofer low and cool the device down at a low volume.
Recommended settings of the amplifier and HU: Volume of HU should not exceed 80%. The amplifier sensitivity is 50%,
subsonic filter frequency (Subsonic) is 5 Hz below the port settings. For example, if you configure the port at 30 Hz, Subsonic is
should be 25 Hz. The low pass filter LPF (the filter that cuts all frequencies above those set for the filter) 63-80 Hz, bassboost to 0.
5. HOW TO USE
EN
6
Voice coil diameter
VC quantity
Cone
Magnet type
Voice coil wire
Surround
Power RMS
Power PMPO
Size
Basket type
2"2"
1 pcs.1 pcs.
Pressed paperPressed paper
FerriteFerrite
Cuprum
FoamFoam
300 W300 W
1200 W1200 W
15"12"
Stamped Steel
with anti-resonant coating
Stamped Steel
with anti-resonant coating
Model
SST-15SST-12
6. SPECIFICATIONS
Cuprum
To Next Page
Loading...