Need help?Do you have a question about the Avdel Genesis nG4 and is the answer not in the manual?
General| Brand | Avdel |
|---|---|
| Model | Genesis nG4 |
| Category | Rivet Tools |
| Language | English |
Essential safety rules for operating, installing, and servicing the tool.
Details on air pressure, pull force, cycle time, noise level, weight, and vibration.
Graphical representation of the tool's physical dimensions and measurements.
Lists the types and sizes of fasteners compatible with the tool.
Explains how to determine the complete tool part number from its components.
Requirements for air supply, including pressure, hoses, and lubrication.
Step-by-step guide for operating the tool with standard fasteners.
Instructions for placing Avtainer® and Maxlok® fasteners using the tool.
Guidance on choosing the correct nose tip based on fastener type and application access.
Detailed steps for fitting standard nose assemblies to the tool.
Procedures for weekly maintenance and inspection of nose assemblies.
Specific fitting instructions for Avtainer® and Maxlok® nose assemblies.
General servicing guidelines applicable to all nose assemblies.
Information on using the stem deflector as an alternative to the stem collector.
Details on fitting and using the extension for deep channel access.
Routine checks, lubrication, and cleaning for daily and weekly servicing.
Safety information for Moly Lithium, Molykote® 55m, and Molykote® 111 greases.
Details on the service kit, annual maintenance, and parts replacement.
Instructions for dismantling and servicing the tool's nose equipment.
Procedures for oil drainage, tool dismantling, and head assembly servicing.
Steps for servicing the pneumatic piston assembly and the air valve.
Procedures for dismantling and servicing the rotary valve and trigger mechanisms.
Assembly instructions for the stop plate, including parts and diagrams.
Information on recommended priming oil and the required priming kit.
Step-by-step instructions for priming the tool after maintenance.
To Next Page
