CouvertureCouvertureCouverture
EN
8 9
Ensure to check all parts are present:
2.PACKAGE LIST
2.1. Package list
liner
Caps
RCD plug
Pump unit
Repair kit
Ari valve
Top cover
(Optional)
Filter cartridge
ground cloth (Optional)
Filtration cartridge support
Pump unit connectors
3.2. RCD test
1. Insert the plug into the
power outlet.
2. Press the «RESET» button,
the indicator light turns red.
3. Press the «TEST» button,
the indicator light turns off.
4. Press the «RESET» button,
the indicator light turns red.
The RCD works properly.
3.1. Site selection
Clean the place A level placeA place with an awning
WARNING : Before proceed to installation your spa, please make sure that the future
location meets the following conditions :
• A level place in order to avoid any defect, hernia or leakage.
• Wide enough to support the pool and its pump unit.
•
• Sheltered from the sun and bad weather.
• Clean and free from sharp objects.
• Devoid of aggressive vegetation on the ground.
Failure to comply with these rules may result in property damage or personal injury.
3. INSTALLATION
WARNING: The RCD plug must be tested before each use..
Do not use if RCD test fails and see chapter 6.1.
Grounding
section.
WARNING : Spa installed on inadequately level surfaces are subject to leaking. forming irregulari-
ties or collapses. which can result in properly damage or serious injury for those in or around the spa
area!
CAUTION : Please choose your set-up area carefully as lawn and other desirable vegetation
undereath the ground cloth (if applicable) wil die. furthermore, try to avoid setting the ground cloth in
areas prone to aggressive plant and weed species, as they may grow trough the ground cloth.
reset pin
To Next Page
Loading...
