Solid blue: Power on
Solid red: Start-up
Solid orange: Only power cable connected
Solid blue: Video on
Solid white: USB cable is connected but camera doesn’t have any streaming out
Gesture control
Blue light blinks for 2 seconds: Successfully wake up gesture control function by any
valid gesture command
Blue light blinks for 4 seconds: Camera recognizes a valid gesture command and
start to action.
[Note] The default of gesture control is off. Please enable it via PTZApp 2 or IP web
page. The effective distance is up to 5-meter away from the camera.
2. Connect the necessary cables.
[Notes]
Secure the USB and RS232 cables with attached
screws.
Make sure the cable is well connected to the
connector on the camera before securing the cable.
To Next Page
Loading...