AVer PTZ310 - OSD Tree; Camera; Advanced Setting; RS232 Command Table

4
OSD Tree
Camera
Go to Advanced Setting -> Control. Make sure the Camera Address, Baud Rate setting is correct.
Advanced Setting
Advanced Setting
Audio
Input Type
Mic in/Line in
Auto Gain Control
Off/On
Noise Suppression
Off/On
Audio Volume
0 ~ 10
Control
Protocol
VISCA/Pelco D/Pelco-P/AW
Camera Address
1~7
Baud Rate
2400/4800/9600/38400
Smart Framing
Off/On
Smart Shoot
Off/On
Number of block
2/3/4
Initial Position
Preset 6/Preset 7/Preset 8/Preset 9
Time to back initial position
5s/10s/15s/20s/25s/30s/35s/40s
RS232 Command Table
Command Set
Command
Command Packet
Comments
IF_Clear
Broadcast
88 01 00 01 FF
I/F Clear
CAM_Zoom
Stop
8x 01 04 07 00 FF
Zoom Control
CAM_Zoom
Tele (Standard)
8x 01 04 07 02 FF
CAM_Zoom
Wide (Standard)
8x 01 04 07 03 FF