In auto detect mode, the device will try
full sequence of the protocols
, and show
the protocol is supported or not. During the
process,
don't plug-in
any other device except
the being-tested adapter/powerbank.
•
Apple 2.4A
This will apply apple recognization
voltages on D+ D- pins to
accelerate
charging
on
apple
devices.
•
Apple MFI Test
This is an apple MFI test routine which can
detect if an apple cable is
MFI authorized
.
Note that the result is
for reference only
.
During the procedure, the device will
require
high volltage
from the
QC3.0
adapter,
this may cause
damage
to the
unauthorized
cable
.
The user shall plug the meter into an
adapter which is
QC3.0 supported
, and plug
in the
cable
into the
USB female
, then begin
the test. Do not plug-in any other device
during the procedure.
To Next Page
Loading...
