Need help?Do you have a question about the AVHzY CT-2 and is the answer not in the manual?
In the QC2.0 mode, the user select the voltage wanted to be triggered by scrolling the left and right keys.
In the QC3.0 mode, the user adjust the voltage by scrolling the left and right keys. Every click will have an effect of 200mV according to the protocol.
In auto detect mode, the device will try full sequence of the protocols, and show the protocol is supported or not.
This will apply apple recognization voltages on D+ D- pins to accelerate charging on apple devices.
This is an apple MFI test routine which can detect if an apple cable is MFI authorized. Note that the result is for reference only.
The meter has the feature of PD(Power Delivery) requesting. To avoid influence to the communications between the adapter and the phone, this feature shall be disabled when not used.
The procedure of the normal mode is : 1. Connect the meter to the adapter by the USB-A male port. Then plug-in a constant-current load(>500mA) into the USB-A female port.
The device provides the software implementation only, require the usage of the accessory from its provider.
This mode can only evaluate the resistance of the Type-C 2 Type-C cable because the meter can only get the resistance of the positive line inside the cable.
Double click the record which you want to read out. Wait for a second, the diagram will be shown:
Set the start threshold, stop threshold, cutoff timeout. Then click "Start" button to start recording.
The list on the middle shows the no, message type, message brief, time and the voltage¤t when the message is sent.
In the QC2.0 mode, the user select the voltage wanted to be triggered by scrolling the left and right keys.
In the QC3.0 mode, the user adjust the voltage by scrolling the left and right keys. Every click will have an effect of 200mV according to the protocol.
In auto detect mode, the device will try full sequence of the protocols, and show the protocol is supported or not.
This will apply apple recognization voltages on D+ D- pins to accelerate charging on apple devices.
This is an apple MFI test routine which can detect if an apple cable is MFI authorized. Note that the result is for reference only.
The meter has the feature of PD(Power Delivery) requesting. To avoid influence to the communications between the adapter and the phone, this feature shall be disabled when not used.
The procedure of the normal mode is : 1. Connect the meter to the adapter by the USB-A male port. Then plug-in a constant-current load(>500mA) into the USB-A female port.
The device provides the software implementation only, require the usage of the accessory from its provider.
This mode can only evaluate the resistance of the Type-C 2 Type-C cable because the meter can only get the resistance of the positive line inside the cable.
Double click the record which you want to read out. Wait for a second, the diagram will be shown:
Set the start threshold, stop threshold, cutoff timeout. Then click "Start" button to start recording.
The list on the middle shows the no, message type, message brief, time and the voltage¤t when the message is sent.
General| Brand | AVHzY |
|---|---|
| Model | CT-2 |
| Category | Measuring Instruments |
| Language | English |
To Next Page
