2. EQUIPMENT REQUIRED (NOT SUPPLIED)
The tools and screws required for the installation must be in good condition and compliant with applicable safety standards.
ciment sable
ø6mm
clé plate de 17
Photocells
10m cable
4 x 6/10
Thank you for purchasing an AVIDSEN automatic gate opener.
This document is a quick start guide detailing the main installation steps as well as the equipment required. To perform the installation, please
download the installation manual at the following address: www.avidsen.com
Warning: The safety instructions and installation instructions can be found in the installation manual. Follow all these instructions, as an
incorrect installation can cause serious injuries.
1. DESCRIPTION
V2
Ref. 114460
EN
OREA550
MOTOR DRIVE
FOR SLIDING GATES
1 24 V geared motor
2 50cm rack and screws
3 Flashing light and screws
4 Remote control
5 Release key
6 Floor fastening pin
7 M8 nut
8 Ø8 washer
9 Ø8 spring washer
10 Photocells and their screws
11 Disengagement label
12 Installation template
13 Backup fuses
1
x 1
3
x 1
3
x 2
3
x 2
2
x 8
2
x 12
2
x 12
4
x 2
5
x 2
6
x 4
7
x 8
8
x 8
9
x 4
10
x 1
10
x 6
10
x 6
10
x 4
11
x 1
12
x 1
13
x 2
To Next Page
Need help?
General
