2. EQUIPMENT REQUIRED (NOT SUPPLIED)
The tools and screws required for the installation must be in good condition and compliant with applicable safety standards.
¡[
[ [
¡[
¡
1 drill
1 at head
screwdriver
1 pencil
1 spirit level
1 x 13mm spanner
1 measuring tape
1 x 19mm box spanner
and 1 x 13mm box
spanner
1 Phillips screwdriver
Flashing light Motor attachment of the
motors
onto the pillars
3m cable
2 x 0.5mm
2
8m cable
2 x 1.5mm
2
Thank you for purchasing an AVIDSEN automatic gate opener.
This document is a quick start guide detailing the main installation steps as well as the equipment required. To perform the installation, please
download the installation manual at the following address: www.avidsen.com
Warning: The safety instructions and installation instructions can be found in the installation manual. Follow all these instructions, as an
incorrect installation can cause serious injuries.
1. DESCRIPTION
1
Main motor with electronic card
2
Secondary motor
3
Remote control
4
Flashing light and screws
5
Rear arm
6
Front arm
7
Post mounting bracket
8
Gate mounting bracket
9
M12 – L40 screw
10
M8 – L25 screw
11
M10 – L90 screw
12
M8 CHC – L30 screw
13
M8 washer
14
M8 spring washer
15
M12 locknut
16
M10 nut
17
M10 spring washer
18
M10 washer
19
M10 - L120 fastening pin
20
Allen key
21
M12 washer
1
x 1
3
x 2
4
x 1
4
x 2
4
x 2
5
x 2
6
x 2
7
x 2
8
x 2
9
x 4
10
x 2
11
x 4
12
x 4
13
x 2
14
x 6
15
x 4
16
x 4
17
x 4
19
x 6
2
x 1
21
x 4
20
x 1
18
x 4
V1
Ref. 114200
EN
ORANE410
MOTOR DRIVE
WITH PIVOTING ARMS
For 2-panel swing gates
attachment of the brackets
on the gate:
Choose a screw/nut system
appropriate for the
thickness of the gate.
There are 4 attachment points
To Next Page
Need help?
General
