To Next PageTo Next Page
Need help?Do you have a question about the Avidyne SkyTrax Series and is the answer not in the manual?
Lists abbreviations used in the manual, providing context for technical terms.
Provides a general description of the SkyTrax system, its capabilities, and supported aircraft.
Details requirements for an airworthy installation and general installation notes for the SkyTrax Receiver.
Lists items included in the SkyTrax package and connector kit for installation.
Details the physical, electrical, and environmental specifications of the SkyTrax ADS-B Receiver.
Explains how the SkyTrax Receiver can be configured with GPS sources and display units.
Describes the USB Type C port used for configuration and monitoring of the SkyTrax system.
Explains how to use the internal Command Interface via the maintenance port for configuration.
Specifies the requirements for the antenna used with the SkyTrax receiver.
Covers the process of installing the SkyTrax Receiver and Antenna, including mounting and wiring.
Details the process of making electrical connections, including crimping and routing the D-Sub harness.
Details the various interfaces available on the P1 connector, including power, serial, and ARINC-429.
Provides a comprehensive checklist for verifying the SkyTrax installation and functionality.
Instructs on setting up a computer with terminal emulation software for SkyTrax configuration.
Explains how to access and use the SkyTrax command interface for configuration and verification.
Details how to manually configure communication ports using the "comconf" command for various protocols.
Addresses the requirement for updating aircraft weight and balance after SkyTrax installation.
Shows wiring connections between SkyTrax and IFD units for installation.
Illustrates interconnect wiring for SkyTrax with IFD and EX-Series MFDs.
Depicts the wiring diagram for connecting SkyTrax with the Entegra II system.
Provides the interconnect wiring diagram for SkyTrax with Aspen EFD1000.
General