11
English
Reset to Factory Default
Settings
If the encoder no longer functions as expected, you can choose to
restore the encoder to its factory default settings.
Use the firmware revert button to reset the encoder.
Figure: Firmware revert microswitch location on the rear of the
encoder
1. Disconnect power from the encoder.
2. Using a straightened paperclip or similar tool, gently press
and hold the firmware revert button.
3. While continuing to hold the button, power the device.
Release the button after three seconds.
Caution — Do not apply excessive force. Inserting the tool
too far will damage the device.
Firmware Revert
Button
To Next Page
Loading...
