Requirements / Restrictions
The base station must support the DECT-GAP profile.
Note:DECT-GAP is a common standard for cordless telephones supported by all FRITZ!Box models with
integrated DECT base stations.
1 Using the FRITZ!Box wizard to register a telephone
1. Click "Telephony" in the FRITZ!Box user interface.
2. Click "Telephony Devices" in the "Telephony" menu.
3. Click the "Configure New Device" button.
4. Enable the option "Telephone (with or without answering machine)" and click "Next".
5. Enable the option "Cordless (DECT) Telephone" and click "Next".
6. Start the registration procedure on the telephone, then click "Connect" and follow the instructions.
7. If you are asked to do so, enter the FRITZ!Box's four-digit PIN on the telephone and confirm it with
"OK".
Note:When using the wizard to register telephones, you do not have to push any buttons on the
FRITZ!Box.
2 Using the telephone's menu to register a telephone
Registering FRITZ!Fon with the FRITZ!Box
1. Switch the telephone on and press the right select key "Register". If "Register" is not displayed above
the right select key:
a. Press the "Menu" key.
b. Select the menu item "Settings" and press "OK".
c. "Registration" > "Register" > "OK"
2. Wait until the message "Press and hold DECT button on base station!" appears.
3. Within 2 minutes: Push the "DECT" button on the FRITZ!Box. Hold down the button for at least 6
seconds until the "DECT" or "Info" LED on the FRITZ!Box begins to flash. The FRITZ!Box is in
registration mode as long as the LED flashes.
4. If you are asked to do so, enter the FRITZ!Box's four-digit PIN on the telephone and confirm it with
"OK".
Note:You only have to enter the PIN if you changed the preconfigured PIN in the FRITZ!Box user
interface in the menu "DECT > Base Station".
To Next Page
Loading...
Need help?
General