6 AutoView 3100/3200 Switch Installer/User Guide
Installation overview
The general procedure for setting up and installing the AutoView 3100/3200 switch is as follows:
• Unpack the AutoView 3100/3200 switch and verify that all components are present and in
good condition.
• Make all hardware connections between the power source, AutoView 3100/3200 switch, target
devices and the Ethernet.
• Turn on the power and verify that all connections are working.
• Configure the AutoView 3100/3200 switch using the console menu interface.
• Make the appropriate mouse setting adjustments.
Figure 2.1 on page 7 illustrates a basic configuration for the AutoView 3100/3200 switch, using the
AutoView 3100 switch as a model for the example.
To Next Page
Loading...
