8
Step5: Open the web browser, such as Internet Explorer, on your laptop / PC, and enter the IP address you just
set on the URL column to access this camera.
In the login page, enter the user name, password, and security code to access.
Note: Please skip the wizard.
Step6: Go to “Config.” “DDNS”, and enable the DDNS service.
If your router supports UPnP, please proceed Step7.
If your router doesn’t support UPnP, click “Save”, and access your router for port forwarding as instructed in “APPENDIX 4
CONFIGURE PORT FORWARDING” at page 19.
Step7: Go to “UPnP”, and enable the UPnP service.
Then, enable “Port Mapping”, and click “Save” to start port mapping.
When the configurations are saved successfully, you’ll see a message indicating the IP address and port
number assigned to your device.
Note down the IP address and port number, and log out the camera.
Check your connection
Step1: Open your web browser, e.g. Internet Explorer.
Step2: Enter the IP address or host name you just noted down and the port number in the URL address box of
the web browser, and see if you can access the login page of the camera successfully.
The format is “http://ipaddress:portnum” or “http://hostname:portnum”.
To Next Page
Loading...
