m542_543_quick_V1.5
Step5: Adjust the viewing angle of the camera.
Figure 5
To adjust the angle vertically, remove the black shield as indicated in Figure 6, and rotate the knobs on both sides to loosen the tile
mechanism and move the lens. Then, secure the tilt mechanism by fasten the knobs to fix the angle.
Rotate
Figure 6
Step6: (Optional) Replace the desiccants with the two packs of desiccants supplied in the sales package, and replace the black shield back as
illustrated in Figure 7.
Note: For the models who do not supply spare desiccants in the sales package, please skip to Step7;
For the models who supply spare desiccants in the sales package, finish the whole installation within 2 minutes in case the desiccants absorb too much
moisture.
Step7: Find the mark as indicated below on both the dome cover and the camera base. Align these two marks to replace the dome cover back
to the camera, as illustrated in Figure 8.
desiccants
desiccants
Mark to align
Figure 7 Figure 8
Note: Please wipe the inner part of the dome cover against the lens for clear images.
To Next Page
Loading...
