Safety Considerations
Avtron Model LPH 400 • Resistive Load Bank
Part Number LPH400D43233
1-3
personnel and metering.
16. Emergency shutdown procedure:
A. In an emergency, shut down the MASTER LOAD switch, then the generator.
The MASTER LOAD switch will allow disconnection of all load steps and still
allow the fan motor to run, cooling any heated elements.
B. The power ON/OFF switch will disconnect both load steps and fan motor. A
customer-supplied Generator Emergency OFF switch should be located near the
Load Bank.
17. An approved electrical fire extinguisher should be on hand at all times.
18. It is the responsibility of the customer to take diligent care in installing the Load Bank.
The National Electrical Code (NEC), sound local electrical and safety codes, and the
Occupational Safety and Health Act (OSHA) should be followed when installing the
equipment to reduce hazards to persons and property.
19. Read and heed all WARNING and CAUTION statements in the manual.
20. Review supplemental metering manual prior to operation.
To Next Page
Loading...
Need help?
General
