To Next PageTo Next Page
Need help?Do you have a question about the AWD AWD250 and is the answer not in the manual?
Advice on keeping the work area clean, well-lit, and free from hazards.
Guidelines for safe use of electricity, including plugs, cords, and wet conditions.
Recommendations for operator safety, including alertness, PPE, and proper attire.
Guidance on operating the tool correctly and performing basic maintenance.
Procedures and checks to perform before operating the machine for the first time.
Instructions for executing straight cuts in mitre saw mode.
Instructions for performing miter cuts at various angles.
Instructions for performing bevel cuts at various angles.
Instructions for performing combined miter and bevel cuts.
Explanation of how to operate the power switch for the saw.
Procedure for adjusting the blade's cutting depth.
Steps for setting up and performing 90-degree cuts.
Instructions for making cuts at angles from 0° to 45° relative to the table.
Guidance on adjusting the guide for performing cross-cuts.
Steps for performing lengthwise cuts using the parallel guide.
Information on proper disposal of the electrical equipment.
General