AWS DeepRacer - User Manual

AWS DeepRacer and Sensor Kit
Getting Started Guide
The AWS Sensor Kit is intended for use only with the AWS DeepRacer

Summary

AWS DeepRacer Components

Vehicle Preparation

Charge Batteries

Instructions for charging the compute and vehicle batteries.

Vehicle Setup and Assembly

Connect Components and Initial Power

Guide to connecting the compute module, battery, and setting initial power.

Sensor Installation

Install LiDAR Sensor

Step-by-step guide to installing the LiDAR sensor on the vehicle.

Fasten LiDAR Sensor

Connect LiDAR Cables

Install Stereo Cameras

Instructions for installing the stereo cameras into the USB-A ports.

Battery Connection

Connect Compute Battery

Procedure for connecting the compute battery using a USB-C cable.

Powering On the Vehicle

Turn On Compute Battery

Wi-Fi Connectivity Setup

Connect Vehicle to Computer via USB

Guide on connecting the AWS DeepRacer to a computer via USB for Wi-Fi setup.

Access Vehicle Interface via Browser

Steps to access the vehicle's interface through a web browser.

Enter Vehicle Access Password

Instructions on locating and entering the vehicle's access password.

Vehicle Power On Sequence

Confirm Status and Power On Vehicle

Verifies battery status and guides on switching on the vehicle with confirmation sounds.

Test Drive Procedures

Access Vehicle via IP and Password

Check Sensor Connection

Manual Mode Test Drive

Autonomous Mode Test Drive

Model Training and Experimentation

AWS DeepRacer Specifications