Product description:
The stripping tool BWZ 5-02 has been designed especially for Axing cable types SKB 88/89/395/92/93, but can also be used
with other cables that have a dielectric diameter of 4.7 ± 1 mm.
The following stripping and cutting blades are available:
It is provided with a reinsertable stripping block with fixed stripping dimensions.
The stripping dimension 8/13 mm is intended for all AXING premium line antenna sockets, the stripping dimension 7/6 mm for
compression connectors CFS 93-xx/97-xx.
The stripping of the outer sheath, shielding and dielectric is done in one step, and the tool can be used by both left- and right-handed
people.
7/6 mm AXING compression connector
adjustable stripping blades: Ø 2.7 – 6.7 mm
cutting blades for coaxial cables:
® Ø 0 – 8 mm
¬ insertable stripping block: 8/13 mm AXING premium line antenna sockets
Work steps
¬
Use of the stripping block:
Use of the stripping blade:
Use of the cutting blade:
To strip coaxial cables of stripping dimension 8/13 mm or 7/6
mm, the stripping block must be plugged in such that the desired
stripping dimension points upwards.
Open stripper, insert the coaxial cable in the curvature of the
block all the way and then close it again. While holding the cable
with the hand, fix the cable on the tool with the thumb and rotate
the stripper no more than 2-3 times by 360°.
Then open the stripper and remove the cable. Next remove the
cut outer sheath and the dielelectric from the cable.
The stripping blade is used for stripping 2.7-6.7 mm in diameter
to any desired length. The stripping blade depth is set using the
upper thumbwheel.
Mark the required stripping dimension on the cable and set the
stripping blade to the diameter of the cable. Then open the
stripper, place the marked cable under the blade and close the
stripper.
While holding the cable with the hand, fix the cable on the tool
with the thumb and rotate the stripper no more than 2-3 times by
360°.
Then open the stripper and remove the cable. Next remove the
cut outer sheath and the dielelectric from the cable.
The cutting blade is designed for cutting coaxial cables up to a
diameter of 8 mm maximum.
®
thumbwheel
®
¬
To Previous Page
Loading...
General