Axis 200+ - FTP; Dialing the Server

Appendix E: The RS232 Serial Port AXIS 200+ Users Manual
94
Configuring
the AXIS 200+
Once you have set up your modems, you need to configure your AXIS
200+ for modem control. You can use any of these methods:
Web browser
FTP
 The Control button
Web Browser
1. On the Configuration - Modem page, enable serial mode by
setting the Serial mode parameter to Full Support.
2. Connect the modem to the AXIS 200+.
3. Turn the modem on.
4. Wait a few seconds and then power up the AXIS 200+.
The new settings will now take effect.
Control Button
For remote installations that are not directly connected to a LAN, you
can alternatively configure the AXIS 200+ for serial mode operation as
follows:
1. Restart the AXIS 200+ by removing and then re-inserting the
power connector.
2. Wait 10 seconds.
3. Press the Control button and keep it pressed until the Snapshot
indicator flashes.
4. Release the Control button.
5. Double click the Control button while the Snapshot indicator
continues to flash.
6. Wait until the Snapshot indicator stops flashing.
7. Restart the AXIS 200+ by removing and then re-inserting the
power connector.