Axis 700 - Integration Guide Manual

1
AXIS 700 Application Integration
Introduction
Scanning using your AXIS 700 can be divided into two types:
• Pull Type Scanning, which is initiated from an application and performed by using the
HTTP protocol
• Push Type Scanning, which is initiated from the control panel of your AXIS 700 and
performed by using the FTP protocol.
This document describes how to integrate your AXIS 700 using both of these methods. It
also describes how you can use FTP to obtain, and possibly modify, a list of available
profiles. It contains the following information:
• Scanning
− HTTP Commands and Headers Required
− Pull Type Scanning
− Push Type Scanning
− Using Microsoft’s Foundation Classes.
− Using Microsoft’s Internet API
• Using the config.ini file to add, modify and remove profiles.
Axis Communications AB
September 1
st
, 1998