Axis P1353 - Configuration Guide Manual

Configuration guide  Mechanical PTZ configuration on the AXIS P135X cameras
Rev: 1.1, Last updated: 02/04/2013 1
Configuration guide
Mechanical PTZ configuration on
the AXIS P135X cameras
This document shows how to configure AXIS P135X cameras to control primarily
a PT head and optionally a zoom lens.
1 Configuration steps
Follow the below configuration steps after connecting the PT head to RS-485/RS-422 serial port
of the camera. Connection schemes are available for particular PT head on driver support pages.
General pin assignment is as follows:
Function
Pin
Notes
RS-485/RS-422 Tx (A)
1 (Tx+)
Tx pair for RS422 and 4-wire
RS-485
RS-485/RS-422 Tx (B)
2 (Tx-)
RS-485A alt. RS-485/RS-422
Rx (A)
3 (Rx+/Tx+ alt Rx+).
Rx pair for all modes
(combined Rx/Tx for 2-wire
RS-485)
RS-485B alt. RS-485/RS-422
Rx (B)
4 (Rx-/Tx- alt. Rx-)