Axkid Move - Removing Child Restraint; Detaching from Vehicle; Seat Cover Procedures; Cover Removal and Fitting

9
WARNING: Never attempt to remove the child restraint whilst your child is still seated in it.
Open the belt lock-o clips (M) on both sides of the child restraint.
Release the vehicle’s seat belt buckle (i) and completely remove the seat belt from the child
restraint. Collapse the support leg (Q). Unhook the tether straps’ (L) from the child restraint and
remove the child restraint from the vehicle. Finally unwrap the tether straps from the vehicle’s anchor
points and then re-hook the straps on to the child restraint.
WARNING: Never use the child restraint without its covers. The covers are an integral safety
feature.
Unclip the tether straps from the child restraint and remove the side impact pad (H) if attached.
Press the harness adjuster button (E) and pull forward on the shoulder straps (not the shoulder
pads) to completely loosen the harness.
Press the red harness release button on the buckle to unfasten the harness and remove the
crotch pad .
Open the zipper on the back of the seat cover. Unhook the shoulder straps from the yoke (S) at
the back of the child restraint.
Unfasten the Velcro® and detach the shoulder pads (B) on the back of the seat.
Pull the shoulder pad straps and shoulder straps out from the seat. Squeeze the plastic clip
and gently pull the headrest free from the seat.
Unhook the elastic loops (i) on both sides of the head rest and remove the headrest cover.
Release and remove the plastic strip along the front of the child restraint . IMPORTANT! Ensure you
pull the plastic strip and DO NOT pull the fabric . Store the plastic strip safely for when you need to fit the
seat cover again. If you do lose the plastic strip you will need to contact your retailer for a replacement.
Unfasten all the press studs (i),(ii), (iii).
Carefully remove the seat cover from around the harness adjuster housing (i). Feed all straps
through the slots in the seat cover and remove the cover.
To fit the cover, reverse the above steps ensuring the harness and shoulder pads are routed correctly
(see steps 9-13 for details on attaching the headrest, harness and shoulder pads).
Removing the child restraint from the vehicle
36
37
38
39
40
41
42
43
44
45
46
Removing and fitting the covers