Important to remember
Do not use a child restraint in a seating
position where an active airbag is tted. If
you still wish to install your Rekid in this
location the airbag must be disconnect-
ed at an authorized service centre. Some
vehicles may be equipped with a switch which
allows you to manually switch the airbag
o. It is important to always check if the
vehicle’s indicator light shows that the airbag
is turned o.
Placing the child restraint
e easiest way to lift the Rekid into the ve-
hicle is with its back rst. To begin push and
hold the adjustor for ISOx(1). Now you
should be able to unfold the ISOx arms
(2). Place the child restraint in the vehicle
with the back of the restraint facing the front
of the vehicle. When installing Rekid in the
front seat it is possible, but not crucial, for
the back of the restraint to have contact with
the dashboard.
Attaching the ISOx ttings
e ISOx brackets are located in the bight
of the back seat between the backrest and
seat. e supplied ISOx-guides (3) may
assist you in locating these brackets, and
they will also help protecting the vehicle’s
upholstery. Push the ISOx ttings through
the guides and clip them onto the brackets.
Installing Rekid rear-facing
9-18kg using ISOx
Never install a child restraint in a passenger seat
where an active airbag is tted
5
Continued on next page
3
2
1
To Next Page
Loading...