AXTON ATC26-DUC User Manual

[CZ] Vhodným nástrojem odstraňte OE plastovou
krytku z předních reproduktorů, abyste měli přístup
ke středo/basovému reproduktoru instalovanému
pod ní.
[EN] Pry-off / remove the OE mounted factory
plastic speaker grill covers in the FIAT Ducato front
doors, to gain access to the mid/woofers installed
underneath.
1
1
2
3
[CZ] Demontujte tři upevňovací šrouby, které
drží plastový kroužek továrních reproduktorů.
[EN] Remove the three mounting screws that
hold the plastic ring out of the factory speakers
in place, to take the OE mid/woofers of the front
doors.
2
3
[CZ] Vyjměte středo/basový reproduktor a
odpojte konektor na zadní straně.
[EN] With the mid/woofer removed unplug the
system connector on the backside of the speaker.
[CZ] Tip: vozidla Fiat Ducato jsou v podstatě
užitkovými vozidly. Z tohoto důvodu, přední
dveře nejsou vytlumené. Doporučujeme nalepit
do prostoru za reproduktor tlumící hmotu Zealum
Finish sound control, která pohltí nežádoucí
vibrace materiálů a zlepší zvukový projev.
[EN] Pro Tip: FIAT Ducato vehicles are basically
duty vehicles. For this reason, the front doors
of the vehicle feature close to no damping with
suitable material. The treatment of the door
surface directly behind the mid/woofer will prevent
rattle and vibrations noises and is therefore highly
recommended.
4
4
INSTALAČNÍ NÁVOD / INSTALLATION
INSTALAČNÍ NÁVOD / INSTALLATION GUIDE
COMPONENT SYSTEM
ATC26-DUC FOR FIAT DUCATO

AXTON ATC26-DUC Specifications

General

Brand	AXTON
Model	ATC26-DUC
Category	Speaker System
Language	English

Summary

Speaker Installation

Remove Front Speaker Grilles

Pry off OE plastic speaker grill covers in front doors to access mid/woofers.

Remove Factory Speaker Mounts and Disconnect

Remove three screws holding factory speaker rings and unplug the mid/woofer connector.

Sound Damping Recommendation

Recommend damping material behind speaker for better sound quality and reduced vibration.

Connect Mid/Woofer and Mount Speaker

Connect system connector to new Axton speaker and mount it using original screws.

Secure Speaker Mounting and Reinstall Grille

Ensure mounting ring is sealed and remount factory plastic grille.

Remove Factory Tweeter and A-Pillar Cover

Remove OE factory installed tweeter and pry off the A-pillar plastic cover.

Mount Axton Tweeter and Adaptors

Mount Axton tweeter into A-pillar cover or use surface mount adaptors.

Connect Inline Crossover and Secure

Connect inline x-over to tweeter via Faston connectors and secure to A-pillar cover.

Connect Tweeter and Finalize Installation

Connect tweeter system connector, secure with tape, and reinstall A-pillar covers.

System Startup and Technical Specifications

System Startup Procedure

Turn on head unit, increase volume, and listen for distortion or vibration.

Technical Specifications Overview

Details on speaker size, configuration, power handling, impedance, sensitivity, and frequency response.