– 6 –
MOUNTING
n Note that the amp-module generates heat, so a well ventilated mounting place
is necessary or it will easily overheat.
n Keepthewireconnectionsasshortaspossible,withsufcientlength,inorderto
minimize power losses and provide a higher audio output of the system.
n For safety reasons route all power and speaker wiring by using the existing
wire channels.
n To minimize damage to the cables, take care that they do not pass through sharp
edged metal. Use rubber grommets were required.
n Lay all cables as far away as possible from the ignition cables, modules in the boot
and under the dashboard, as these create interference.
n Add a main fuse (60 A) to the (+) power cable in a distance of not more than
30 cm from the positive battery pole (re hazard!)
n Keep the length of the power cable as short as possible.
n The power cable should have at least a cable cross section of 10mm
2
(8 Gauge
AWG). Smaller cross sections are reducing the output power, are causing
distortions and may be triggering the overheat protection of the amp-module.
1. Position the mounting brackets.
2.Usethetappingscrewstoxthem.
To Next Page
Loading...
