Installation instructions for part AX-GMCL2
®
CAUTION!
All accessories, switches, climate controls panels, and
especially air bag indicator lights must be connected before cycling
the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Provides NAV outputs (parking brake,
reverse, and speed sense)
• Retains chimes through an onboard speaker
• Pre-wired ASWC-1 harness (ASWC-1 sold
separately)
• Designed for non-amplified models, analog
amplified models, or when bypassing a
factory amplifier
• Retains balance and fade
• Micro “B” USB updatable
INTERFACE FEATURES
• Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
TOOLS REQUIRED
AX-GMCL2
GM Data Interface
2000-2013
Connections to be made ................................................... 2
Installing the AX-GMCL2 .................................................. 3
Initializing the AX-GMCL2 ................................................ 3
Table of Contents
• AX-GMCL2 interface • AX-GMCL2 harness
INTERFACE COMPONENTS
APPLICATIONS
See application list inside cover
To Next Page
Need help?
General