10
Ayon Audio – Hart 18 – 8101 Gratkorn – Austria – Phone: +43 3124 24954
www.ayonaudio.com
9. How to operate remote control ( RC )
ayon
remote control
A. Volume: Use these buttons to adjust the volume.
B. Mute: Use this button to mute the sound.
Battery Installation
You will require a small size Allen Hex Wrench, provided.
1) On the top and bottom of the remote you will see 4 hex screws on each end of the remote.
Using the provided Allen Wrench, remove the 2 top UPPER section hex screws only. Carefully
separate the top panel of the remote control from the lower panel of the remote control.
Handle carefully as do not damage the signal diode.
After separation the top panel, insert 2 x AAA batteries, observes the polarity!
2) Test it and then re-assemble.
Remote Control Operation
Point the remote control emitter diode to the front of the amplifier. To increase the volume,
depress the right button with the upward facing arrow. To decrease the volume, depress the
left button with the downward facing arrow. The mute button is located above the volume
control buttons.
When the remote control range is has become shortened, replace the batteries. Always
replace the batteries as a new PAIR! Check Voltages and DO NOT USE RECHARGEABLE
Batteries. Use a dry soft cloth to clean the remote control and battery spring when replacing
with new batteries. Keep remote control, dry, out of direct sunlight or heat. DO NOT DROP!
To Next Page
Loading...