Need help?Do you have a question about the Ayre AX-7 and is the answer not in the manual?
General| Type | Integrated Amplifier |
|---|---|
| Total Harmonic Distortion | < 0.1% |
| Signal-to-Noise Ratio | 100 dB |
| Inputs | 4 x RCA, 1 x XLR |
| Outputs | 1 x RCA, 1 x Speaker |
Guidance on optimal placement for the integrated amplifier, ensuring adequate airflow.
Details on balanced and unbalanced inputs, FET switches, and input selection icons.
Instructions for connecting to recorders for making audio recordings via tape out jacks.
Information on connecting loudspeakers, warnings about grounding output terminals.
Explanation of the FET-based volume control, its 66 levels, and default setting.
Details on selecting inputs using front panel buttons or remote control with icons.
How to temporarily mute the audio output to zero volume and reset behavior.
Using the tape output for recording, connecting to the 'Moon' input.
How to turn the front panel display on or off and its behavior with commands.
Information on energy-efficient standby mode and its effect on output stage and power consumption.
Using the AX-7 in home theater systems for direct routing of two-channel sources.
Explanation of the necessary break-in period for the amplifier to reach full sonic potential.
Details the amplifier's continuous power output into 8 and 4 ohm loads.
Specifies the maximum acceptable input voltage levels for balanced and unbalanced connections.
Defines the input impedance for both unbalanced and balanced audio connections.
Details the pinout and polarity for XLR balanced audio inputs (Pin 1, 2, 3).
Specifies the amplifier's gain in dB at maximum volume setting.
Indicates the frequency range over which the amplifier operates.
Details power usage in standby and operating modes without signal.
Provides the physical dimensions of the amplifier in inches and centimeters.
States the weight of the amplifier in pounds and kilograms.
Details the five-year limited warranty, transferability, and claim process.
To Next Page
