5. Plug the other end of this cable into the POE port on the power supply.
6. Plug the power supply into the wall.
7. Plug another Ethernet cable into the LAN port of the power supply,
and connect the other end of the cable to one of the LAN ports on your
router. The bottom two (green) lights should be lit the other “signal”
lights WILL NOT LIGHT – they are only active on a Remote Hub.
8. Check your account on ayrmesh.com and make sure the Hub is checking
in. Log in to ayrmesh.com and select Manage Network, then Check
AyrMesh Hubs; make sure your Hub is checking in to ayrmesh.com
(may take 10 minutes)
Ayrstone AyrMesh Hub Setup 3
To Next Page
Loading...