AYRSTONE AyrMesh User Manual

1
Start Here
Turn over for shorter instructions
Quickstart Guide - AyrMesh
®
Hub2x2C
Check Contents of the box:
1. Hub2x2C
2. Antennae (2)
3. Power Supply
4. Power Cord
5. (2) Ethernet Cables (1
shorter, 1 longer)
6. (2) Zip Ties (not shown)
7. (2) Screws (not shown)
1
Remove the door, write down the MAC address
of your Hub, write it here, and keep it with these
directions in a safe place:
MAC Address
If you don't have an account on AyrMesh.com,
create one now using a device connected to your
network (not a cellphone unless it's connected to
your router via WiFi):
2
3
4
5

AYRSTONE AyrMesh Specifications

General

Brand	AYRSTONE
Model	AyrMesh
Category	Switch
Language	English

Summary

Getting Started: Initial Setup

Record Hub MAC Address

Locate and write down the Hub's MAC address in a safe place.

Assemble and Connect Hub to Router

Attach Hub Antennae

Screw the antennae onto the Hub's top threads finger-tight.

Connect Ethernet to Hub Port

Plug one end of an Ethernet cable into the Hub's port.

Connect Ethernet to Power Supply (POE)

Connect Power Supply LAN to Router

Connect Power Supply to Wall Outlet

Verify Initial Power and Signal Lights

Confirm Hub Operation and Status

Hub Network Check-in Time

Interpreting Signal Light Status

Understanding Signal Lights

Troubleshooting Common Issues

Troubleshooting No Power or Lights

Check power cable connections, wall outlet, and power supply unit for issues.

Troubleshooting Hub Offline Status

Verify Ethernet connections, router DHCP, and consider a router factory reset for connectivity.

Troubleshooting WiFi Connectivity

Avoid special characters in SSID/passkey; check spelling and signal obstructions.

Troubleshooting Network Instability

Prevent crashes by avoiding secondary routers, static IPs, and network loops.