To Next PageTo Next PageHow to fix burner that wont light on my AZ Patio Heaters FS-1010-T-12 Outdoor Fireplace?
If the burner on your AZ Patio Heaters Outdoor Fireplace won't light, it could be due to a blockage in the orifice. Clear any blockage that you find. Another possibility is that the control knob isn't in the ON position. Make sure to turn the control knob to the ON position.
Why is the burner flame low on my AZ Patio Heaters Outdoor Fireplace?
A low burner flame on your AZ Patio Heaters Outdoor Fireplace can be caused by several factors. First, check if the gas pressure is low; if so, turn the cylinder valve OFF and fill the cylinder. If the outdoor temperature is below 40ºF and the tank is less than 1/4 full, use a full cylinder. Also, inspect the burner and orifices for any blockages.
What to do if AZ Patio Heaters FS-1010-T-12 Outdoor Fireplace produces thick black smoke?
Thick black smoke or carbon build-up from your AZ Patio Heaters Outdoor Fireplace can be caused by dirt or film on the burner. Clean the burner to resolve this. Alternatively, there might be a blockage in the burner. Remove any blockage and clean the burner inside and out.
General| Model | FS-1010-T-12 |
|---|---|
| Category | Outdoor Fireplace |
| Type | Patio Heater |
| Fuel Type | Propane |
| Material | Steel |
| BTU | 40, 000 |
| Power Source | Propane |
| Diameter | 32 inches |
| Ignition Type | Piezo |
| Warranty | 1 Year |
| Color | Bronze |
| BTU Output | 40, 000 BTU |
Details hazards of death, serious injury, or property damage from fire, explosion, burn, or CO.
Steps to take if you smell gas: shut off, extinguish flame, move away, call supplier.
Keep combustibles away, maintain clearances, avoid volatile areas, and store propane safely.
Fire pit produces CO; use only outdoors in ventilated areas. CO is an invisible killer.
Instructions for performing leak tests on gas connections using soapy water outdoors.
Covers CO hazard, hot surfaces, pre-operation checks, and lighting procedures.
