Azbil TY6300Z1000 - Settings; Temperature setting; Switching operation; Operation check

12
AB-6601
Figure 23. Heating operation
z
Operation check
IMPORTANT
•
Because of delayed response of the
detecting element, the differential gap may
seem to be large.

As necessary, adjust the mounting location,
etc. to eliminate delayed response.
(1) Turn on the power to the product.
(2) Turn the setting knob to set the setpoint.
(3) Check that the control target equipment normally
runs or stops as intended.
(4) Turn off the power to the product.
Temperature of
sensing element
[°C]
Differential gap
2.5 °C (fixed)
Setpoint
Between terminal
R and B: Close
Between terminal
R and W: Open
When temperature falls
Between terminal
R and B: Open
Between terminal
R and W: Close
When temperature rises

Settings
z
Temperature setting
Turn the setting knob on the front of cover to set
the indicator (needle) at the desired temperature
(setpoint).
Turn the setting knob clockwise to raise the
temperature setting or counterclockwise to lower it.
Figure 20. Temperature setting
z
Switching operation
When the temperature rises and reaches the
setpoint, the contacts between terminal R and B
close; after the temperature falls by the amount of
the differential gap, the contacts open.
When the temperature falls and reaches the
setpoint, the contacts between terminal R and W
close; after the temperature rises by the amount of
the differential gap, the contacts open.
Be careful to do wiring.
Figure 21. Switch conguration
Figure 22. Cooling operation
Indicator (needle)
Setting
knob
Heating
Cooling
Temperature rise
Micro switching
Temperature of
sensing element
[°C]
Differential gap
2.5 °C (fixed)
Setpoint
Between terminal
R and B: Close
Between terminal
R and W: Open
When temperature falls
Between terminal
R and B: Open
Between terminal
R and W: Close
When temperature rises