Azores Networks AX1800 User Manual

 The Single Router or Master AP in a Mesh Router Set can be connected according to the diagram above.
Note the DSL/PON/Cable Gateway must be connected to the WAN port of the AP. The AP is connected to
the Internet when the LED light is steady green. If you can, try place the Single Router or Master
AP in an open area like on a table or a shelf.
 Wired devices can be connected directly to LAN port for Internet access; wireless devices can use
the network name (SSID) & password (see the sticker on the bottom of the Single Router or Master
AP) to connect to Internet.
MESH SETUP STEPS
Place the Slave AP at a proper location based on your home layout. After powering on again, Slave AP
is all set when the LED is steady green. To optimize wireless performance, place the Slave AP in a location
that minimizes the barrier (such as wall, door, and floor) between the Master and the Slave AP. We recommend
one wall/door/floor between the two APs. You can connect the Slave AP to your Master AP via network cable
(preferred method) or wirelessly.

Azores Networks AX1800 Specifications

General

Brand	Azores Networks
Model	AX1800
Category	Network Router
Language	English