Need help?Do you have a question about the B-Max Technology B-Home and is the answer not in the manual?
General| Brand | B-Max Technology |
|---|---|
| Model | B-Home |
| Category | Burner |
| Language | English |
Hysteresis for water temperature regulation; burner restarts when setpoint is reached.
Represents the maximum level of water temperature before burner action.
Defines how many times the burner attempts ignition before signaling an error.
Time the LCD display remains illuminated after no button press.
Parameter to enable the functionality of a second tank.
Enables or disables the external thermostat control.
Allows visualization and management of water temperature on the main display.
Time limit for ignition; burner stops and signals error if not made.
Wait time after lighting before declaring the burner as operational.
Interval between automatic cleaning cycles for the combustion grill.
Duration of the cleaning process where the fan operates at maximum power.
Time delay in the activation of any alarm condition.
Value the optical sensor must reach to confirm ignition completion.
Optical sensor level that, if not maintained, causes the burner to stop.
Time assigned to the resistance to ignite fuel and activate the burner.
Waiting time for the burner to turn off when using an external thermostat.
Time the optical sensor must continuously detect above a specified value.
Fan operating time at max power after burner shutdown to burn residues.
Fan operating time at max power after alarm shutdown to burn residues.
Regulates the time (seconds) for the initial loading of pellets.
Power of ventilation during the first phase of ignition.
Time between successive loads of pellets.
Charging time between pellet preload and flame stabilization.
Charging time for pellets during flame stabilization.
Auger loading time when it coincides with fan cleaning.
Represents the loading time made by the system for each power level.
Represents the fan power (in percentage) during the charge phase.
Represents the fan power (in percentage) during flame stabilization.
Represents the fan power (in percentage) during the cleaning phase.
Fan speed at each power level, dependent on fuel and draft.
Time between mechanical cleaning operations.
Regulates the output of the mechanical cleaning system.
Fan speed on the external auger.
Process to weigh pellet loading with a balance for calibration.
To Next Page