Need help?Do you have a question about the Baby Lock EMP6 and is the answer not in the manual?
General| Type | Embroidery Machine |
|---|---|
| Needles | 6 |
| Maximum Embroidery Speed | 1000 spm |
| Connectivity | USB |
| Display | LCD |
Procedure for removing the motor and carriage covers.
Procedure for disassembling the machine's bed cover.
Procedure for removing the right arm cover.
Procedure for attaching the left base cover and its components.
Procedures for removing the tension nut, bracket, and related components.
Procedures for removing thread eyelet base and PCB assemblies.
Procedure for disassembling the thread take-up lever cover.
Procedures for disconnecting the arm bed and removing the idle pulley.
Procedures for entering and selecting main board or panel board test modes.
Tests for motors, sensors, and A/D values.
Tests for needle position, spacing, and threader adjustments.
Tests for panel functions: switches, LEDs, LCD, USB, EEPROM.
Adjusting needle bar front/back, right/left positions, and spacing.
Adjusting needle bar height, length, spacing, and hook timing.
Adjusting rotary hook stopper clearance and presser foot height.
Adjusting needle threader positions and hoop sensors.
Adjusting Y-belt, X-belt, motor belt, and timing belt tensions.
Procedure to verify correct needle threading operation.
Lubrication and maintenance points for dealer service at 500 and 1,500 hours.
Daily cleaning and oiling procedures for the end user.
List of error messages and corresponding page numbers for troubleshooting.
Diagnostic steps when the machine power does not turn on.
To Next Page