09
Step 3: Attach the canopy
1. Your canopy should come pre-assembled. To attach it to the
frame, rst secure the bottom side of the connector to the frame, then
pull and clip the topside over and into place. Repeat on other side.
Make sure the connectors are as close to the middle of the frame as
they can be (as shown in the pictures below, there should be no gap
between the bumper bar and the canopy connectors).
2. You may wish to have the front peak of the canopy ipped
forward to provide a little extra protection
3. Finally pull the fabric over the bassinet into place.
Your bassinet is now set up and ready to use!
WARNING!
Only use the bassinet in a at position. Do not recline.
To Next Page
Loading...