MOVE 360
DE
EN
FR
52 53
NL
INSTALLATION OF SUPPORT LEGRELEASE AND STORAGE OF SUPPORT LEGS
Take the Support leg out from the storage
bin at the bottom of the base
Press the expansion button to pull the
support leg out
Place child in car seat and secure with
5-point seat belt system
Put the bottom of the seat in the displayed state as
from the storage bin at the bottom of the base.
Notice: when the Support leg touches the car surface, the Support leg indicator must
• Check and tighten ISOFIX attachment, Support leg and 5-point seat belt system
• The 5-point seat belt should not be twisted or wound.
• When installing the car seat by rearward facing and children’s height is less than
75cm, it must use new born cushion.
• We recommend to install car seat with ISOFIX attachment guider.
• The seat must be as close to (against) the back of the vehicle seat as possible
• The child restraint system should not be installed in the position where the air-
bag is installed in the rearward facing position.
The 100-150cm I-Size Booster seat cannot use
the Support leg.
Use your hands to support your legs and pull them
out to the outside.
Support leg storage According to the reverse operation of the release of the support leg,
22
To Next Page
Loading...
Need help?
General
