6
• To remove the comb guide,
ensure the appliance is switched
o. Push the tab on the rear of the
comb guide away from the head
and lift o.
Taper Control
The taper control lever enables
ne cut adjustment for precision
clipping.
• To increase the cutting length,
push the lever down.
• To reduce the cutting length,
push the lever up.
INSTRUCTIONS FOR USE
Charging the Appliance
• Before using the appliance
for the rst time, charge the
battery continuously for 3
hours. Maximum battery
capacity will only be reached
after 3 completed charging and
discharging cycles.
• Plug the charging adapter into
a suitable mains power socket.
The red LED indicator light will
ash when correctly connected
to the mains power and will
continuously ash until the
battery has fully charged. When
the battery is fully charged the
LED indicator light will stop
ashing but remain on.
NOTE: Always place the clipper in
the base with the ‘I/0’ switch in the
0/OFF position.
• When the clipper is running low
on charge, the LED indicator
light will ash, warning there
is approximately 3 minutes
of battery use remaining. A
3 hour charge will provide
approximately 120 minutes
use. A 30 minute quick charge
will provide approximately 30
minutes use.
• If the charging light starts to
ash rapidly (more than 4 ashes
per second) then the appliance
is faulty. If this happens then
please stop charging and remove
the adapter from the mains
and contact the customer care
service.
Preserving the Batteries
• In order to maintain the optimum
capacity of the rechargeable
batteries, the appliance should
be recharged for 3 hours
approximately every 3 months.
• Using the clipper on the
mains - ensure that the clipper
is switched o. Plug into a
suitable mains socket. Wait for
approximately a minute, and
then switch on.
To Next Page