5
PROFESSIONAL CORD/
CORDLESS CLIPPER
EDM TECHNOLOGY
A heavy-duty, lithium powered
cordless clipper with precision
engineered Japanese steel blades
and a high-torque brushless motor
to deliver outstanding cutting
performance and precise control.
FEATURES
• High power cord or cordless
performance
• 45 mm precision engineered
Japanese steel blades with a
super sharp V cutting angle
• Advanced lithium for sustained
power performance
• 3 hour charge time for 120
minutes run time
• High-torque brushless motor for
long-lasting power and speed
• 5 position adjustable taper lever
(0.8 – 1.4 – 2 – 2.8 – 3.5 mm)
• 8 comb guides
• Charging unit
• Including cleaning brush and
lubricating oil
PREPARATION FOR USE
General
• Always inspect the appliance
before use to ensure the clipper
blades are free from hair, debris
etc.
• Use on clean, dry hair that has
been combed until tangle-free.
Oiling Instructions
• For optimum cutting performance,
it is highly recommended to oil the
blades after every use.
• When using the oil for the rst
time, unscrew the cap and cut o
the very end of the plastic tube
with a pair of scissors.
• Remove the blade guard and
switch the appliance on.
• Holding the clipper at a 45
degree angle, gently squeeze
the oil tube and apply 2 drops
directly onto the blades.
• Leave the unit on for a further
few seconds to allow the oil to
thoroughly spread along the
length of the blades.
• Switch o the unit and remove
any excess oil by gently dabbing
with a cloth before using on hair.
Comb Guides:
This appliance is supplied with 8
comb guides:
1.5mm (1/16”) #.5
3mm (1/8’’) #1
4.8mm (3/16”) #1.5
6mm (1/4’’) #2
10mm (3/8’’) #3
13mm (1/2’’) #4
16mm (5/8’’) #5
19mm (3/4’’) #6
• To attach a comb guide, ensure the
appliance is switched o. Position
the comb guide over the front of
the clipper blade and slide over
the head. Push and click the rear of
the comb guide into position.
ENGLISH
To Next Page
Loading...
