STYLING ADVICE
• Section dry hair evenly and comb through before styling.
• Press the lever and place the tong midway up the hair section and spread hair evenly
between the lever and the barrel.
• Once hair is in place carefully let go of the lever so the hair is held securely
between the lever and the barrel. Gently slide the tong down to the hair ends.
NOTE: If using this product on someone else, wrap all the hair section around the
barrel before you let go of the lever.
• Wind the hair around the barrel at a slight angle, so the hair wraps around the barrel in
a spiral motion. As you wind the hair around the barrel, ensure the hair is distributed
evenly so the entire section is touching the barrel; try not to overlap the hair.
• Hold in place for 5-8 seconds depending on the texture and length of the hair.
• To remove the tong from the hair, press the lever and pull tong away.
• Allow the curl to cool before styling it further.
• Repeat as necessary through the remaining sections. Use the heat protection mat to
place your styler on between each section to protect surfaces.
• After use, press and hold the ‘I/0’ button for 1-2 seconds to switch your styler off and
unplug.
• Allow to cool completely before storing away. For extra protection, wrap the styler in
the heat protection mat.
To Next Page
Loading...
