EasyManua.ls Logo

BaByliss 8430 - Instructions for Use; Maintenance and Storage; Bulb Replacement; Battery Replacement

BaByliss 8430
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
the surface of the mirror when left
unattended, as this may cause a re.
Let the appliance cool down to room
temperature before storing. Store the
appliance in a cool and dry area, out
of childrens reach.
BULB REPLACEMENT
Important: always turn switch to o
position (0), allow to cool and unplug
before replacing light bulbs.
This BaByliss mirror uses two
3.6V-0.5A bulbs. Do not use bulbs
greater than 3.6V.
1. Turn the back of the appliance to
the left to open, then lift o the
back of the housing.
2. Unscrew the old bulbs and replace
with the new bulbs.
3. Carefully replace the back housing
and turn it to the right.
BATTERY REPLACEMENT
This mirror uses 3 AA batteries.
To insert batteries, turn the back of
the appliance to the left to open, then
lift o the back of the housing. Insert
3 AA alkaline batteries, direction as
indicated on battery compartment
(Alkaline batteries will ensure the best
perfomance and longest life for your
appliance). If you are not going to
use the unit for a long period of time,
or if the battery is dead, remove the
battery from the unit. After inserting
batteries, close battery compartment
and turn unit to I position.
CHROME MIRROR
This lighted mirror with triple
magnication is very elegant and will
make it easy for you to apply your
make-up. It has an attractive design
to suit most interiors.
The halo-lighting around the mirror
is soft and even, perfect for applying
make-up.
The mirror will swivel so that you can
adjust it to any angle. It works with a
transformer (supplied) or cordless on
3 AA batteries (not supplied).
INSTRUCTIONS FOR USE
Set the frame to the desired angle.
Connect the cord to the appliance
(at the back of the mirror), then plug
in, or place batteries in the battery
compartment.
Press the switch button to «I» to turn
lighting on.
After use, always switch o the
appliance.
MAINTENANCE
The lighted mirror is designed mainly
for home use and requires little
maintenance. If cleaning becomes
necessary, unplug the electrical cord
and wipe the outside of the appliance
with a damp cloth. Clean the mirror
with a glass cleaner. Do not switch the
mirror on until it is completely dry.
STORAGE
Always unplug the appliance after
use.
Be sure direct sunlight will not strike
ENGLISH

Related product manuals